Model MB-350; 220 Volt, 3 Phase, Mandrel Rotary Draw Tube and Pipe
Bender.
Model MB-350 ,Mandrel Rotary Draw Tube and Pipe Bender
Model MB-350; 220 Volt, 3 Phase, Mandrel Rotary Draw Tube and Pipe
Bender.
 | Touch screen operator interface with capability to program up to 140 programs, with up to 10 bends per program. |
| 10’ Extraction Table |
| Rotary positioning carriage with 4 manual stops. |
Max Bending Capacity:
| Round Mild Steel - 3"OD x .125" Wall |
| Round Aluminum - 3"OD x .188" Wall |
| Round Stainless - 3"OD x .065" Wall |
| Square Mild Steel - 2"x2" x .188" Wall |
| Solid Bar Mild Steel - 1.181"OD |
Additional Specifications:
| Right Handed Bender |
| Single Stack Tooling |
| Bend axis is driven by electrical mechanical drive system. Linear feed and plane of bend rotation are by rotary degree positioning carriage with linear scale and 4 manual linear stops. |
| User friendly touch screen interface allows for storage of programs, speed of bend changes, amp meter readings, counter for number of bends, and spring back values. |
| Clamp die has hydraulic and mechanical locking system that reduces the possibility of slippage. |
| Mandrel extractor uses powerful hydraulic system to insert, hold, and extract the mandrel. Also employed is an adjustable mandrel positioning device. |
| Follower die is positioned and held tight against rotary die and wiper die. |
| Foot pedal control works in conjunction with touch screen instructions. On screen safeties ensure improper operations can not be completed. |
| Maximum Bend Radius - 12" CLR |
| Maximum Angle - 190° |
| Maximum Length over Mandrel - 10" |
| Bending Speed (DOB) - 18 degrees per second |
| Accuracy of DOB - +/- 0.50° |
| Machine Weight - 2100 lb |
| 220V x 60Hz x 3 Phase |
Bending capacity may vary depending on OD, WT, CLR, material, and supply of
material. RMD retains the right to amend designs from time to time without any
prior notice. The buyer must provide 10 pieces of test bending material for
each different die and mandrel size specified. Machine will be tested with
tooling and material before shipment. Manufacturer reserves the right to hold
shipment until successful testing has been performed. If desired, factory
onsite training can be hired for $780 per day plus travel and lodging costs.
Manual mandrel tube benders that are economical models available to the marketplace for those who have a limited budget, and don't have the need for production mandrel pipe benders.
NC mandrel tube benders that use a PLC based controller enables easy operator interface with machine control and enables easy data input. The NC control rotary collet hydraulic tubing bender should offer high technology and value.
E-mail us at:
Sales@interplantsales.COM
